Under the Energy Efficiency Obligation Scheme, energy suppliers must support energy efficiency projects in businesses and homes across Ireland.
SEAI is the administrator of the Energy Efficiency Obligation Scheme (EEOS). The scheme started in 2014 and will run until at least 2020. It places obligations on energy suppliers and distributors to deliver energy savings. This is true for all energy types, including electricity, gas, and solid fuel.
Companies who sell large amounts of energy are known as obligated parties and they have targets under the scheme. Obligated parties offer supports to make your home or business more energy efficient. For every unit of energy saved through these projects, they achieve energy credits towards their targets. This will help Ireland to reach national and European energy saving targets.
Eligible measures for energy credits
Homeowners can get support from any obligated party – there is no requirement for their energy supplier to provide support. For an obligated party to claim energy credits, they must support the installation in some way and they must be involved before the measures were installed. It is recommended that homeowners contact their energy supplier or any of the other obligated parties to see if they are willing to provide support, before works begin.
The energy saving credits table in the downloads below contains the energy credits that can be claimed for each eligible measure. The property owner must give written consent to the obligated party agreeing to assign energy credits to them. We will audit 5% to 10% of all energy efficiency measures completed under EEOS.
|Eligible measures include:|
High efficiency boiler, solar water heating and heat pump installation.
Home energy report and shower energy monitor.
In the non-residential sector, eligible measures are those applied to your business or organisation. If you are undergoing any of these measures, the obligated party will calculate the energy credits achieved in accordance with our guide on authenticating and claiming energy credits below.
As for residential measures, an obligated party can only claim energy credits from the installation of an energy efficiency measure if they supported the installation in some way and they were involved before the measures were installed.
|Eligible measures include:|
Ventilation and air conditioning
Motors, drives and pumps
Combined heat and power
Temperature control, pipe insulation, relocation and replacement.
Leak repair, optimisation, redesign and replacement.
Steam trap inspections, facility programmes and BMS.
Supports from obligated parties
Obligated parties must show that they were essential to the work on your home or business. This means it would not have been carried out at all, as quickly, or to the same extent without their involvement. The support they provide to you may be technical, financial, or a mixture of both.
Financial support can range from:
- A direct monetary contribution towards a project
- Facilitating low interest loans
- Negotiating discounts on materials (e.g. lighting supplies, high efficiency pumps, and motors)
- Reduced energy prices or tariffs
Technical support to a project may be:
- Providing a certified energy practitioner to carry out energy audits
- Implementing energy management systems
- Identifying energy efficiency opportunities
- Measuring and verifying savings once opportunities have been realised
They could also provide advice on planning, sourcing, and installing technologies. This might include combined heat and power, building management systems, and heat recovery systems.Connect with an obligated party
For more information on the rules and standards around the scheme, please refer to the documents below.
- ECMS template and instructions for uploading measures
- Voltage optimisation measurement and verification guide
- SI 131 of 2014
- Energy Efficiency Directive 2012
- EEOS product application form
- EEOS guidance document
- Energy saving credits table
- Guidance on authenticating and claiming energy credits
- Boiler optimisation technology sign off sheet
- Code of practice and technical specification
If you require tools or calculators, view our Tools page.